119
GS748T Smart Switch
Multicast Router Configuration
This page configures the interface as the one the multicast router is attached to. All IGMP
packets snooped by the switch will be forwarded to the multicast router reachable from this
interface. The configuration is not needed most of the time since the switch will automatically
detect the presence of multicast router and forward IGMP packet accordingly. It is only
needed when you want to make sure the multicast router always receives IGMP packets from
the switch in a complex network.
To access the Multicast Router Conf
iguration page, click Switching Multicast IGMP
Snooping
Multicast Router Configuration.
To configure the multicast router settings:
1. Select
the check box associated with each interface you want to configure. Select the
check box in the heading row to apply the same settings to all interfaces.
2. Use Multi
cast Router to enable or disable Multicast Router on the selected interfaces.
3. Click AP
PLY to update the switch with the changes.
4. Click CA
NCEL to abandon the changes.
To Next Page
Loading...
