NETGEAR GS748T - ACL Wizard

205
GS748T Smart Switch
ACL Wizard
The ACL Wizard allows you to configure ACL permissions for devices based on the source
and destination of MAC address, IP address, and port IDs.
To display the MAC ACL page, click Security
 ACL Wizard.
When a packet meets the match criteria of a rule, the specified rule action (Permit or Deny) is
taken and the additional rules are not checked for a match; configure as follows:
• Sele
ct Devices Based on Source MAC Address. Permit and Deny options are used to
configure devices based on source MAC address.
• Sele
ct Devices Based on Destination MAC Address. Permit and Deny options are used
to configure devices based on destination MAC address.
• Sele
ct Devices Based on Source IPv4 Address. Permit and Deny options are used to
configure devices based on the source IPv4 address.
• Sele
ct Devices Based on Destination IPv4 Address. Permit and Deny options are used
to configure devices based on the destination IPv4 address.
• Sele
ct Devices Based on Source IPv6 Address. Permit and Deny options are used to
configure devices based on the source IPv6 address.
• Sele
ct Devices Based on Destination IPv6 Address. Permit and Deny options are used
to configure devices based on the destination IPv6 address.
• Sele
ct Devices Based on TCP/UDP Source Port ID. Permit and Deny options are used to
configure devices based on the TCP/UDP source port ID.
• Sele
ct Devices Based on TCP/UDP Destination Port ID. Permit and Deny options are
used to configure devices based on the TCP/UDP destination port ID.
• Sele
ct Devices Based on IPv6 L4 Source Port ID. Permit and Deny options are used to
configure devices based on the IPv6 layer 4 source port ID.
• Sele
ct Devices Based on IPv6 L4 Destination Port ID. Permit and Deny options are used
to configure devices based on the IPv6 layer 4 destination port ID.