NETGEAR GS748T - Server Log Configuration

243
GS748T Smart Switch
Server Log Configuration
Use the Server Log Configuration page to allow the switch to send log messages to the
remote logging hosts configured on the system.
To access the Server Log Configuration page, click the Monitoring
 Logs tab, and then click
the Server Log link.
To configure local log server settings:
1. Use the rad
io buttons in the Admin Status field to determine whether to send log
messages to the remote syslog hosts configured on the switch.
• Enable: Messages will be sent to
all configured hosts (syslog collectors or relays)
using the values configured for each host.
• Dis
able: Stops logging to all syslog hosts. Disable means no messages will be sent to
any collector/relay.
2. In the Local UDP
Port field, specify the port on the switch from which syslog messages are
sent.
3. Click App
ly to save the settings.
The Server Log Configuration area also displays the following information:
• T
he Messages Relayed field shows the number of messages forwarded by the syslog
function to a syslog host. Messages forwarded to multiple hosts are counted once for
each host.
• T
he Messages Ignored field shows the number of messages that were ignored.