85
GS748T Smart Switch
LACP Port Configuration
To display the LACP Port Configuration page, click Switching LAG Advanced LACP
Port Configuration.
To configure LACP port priority settings:
1. Select
the check box next to the port to configure. You can select multiple ports to apply
the same setting to all selected ports.
Note: You cannot select ports that are not participating in a LAG
2. Configure the LACP Priority value for the selected port. The field range is 0–255. The
default value is 128.
3. Conf
igure the administrative LACP Timeout value.
• L
ong. Specifies a long timeout value.
• Short.
Specifies a short timeout value.
4. Click Canc
el to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
5. If you make any change
s to this page, click Apply to send the updated configuration to the
switch. Configuration changes take effect immediately.
To Next Page
Loading...
