64
GS748T Smart Switch
LLDP Port Settings
Use the LLDP Port Settings page to specify LLDP parameters that are applied to a specific
interface.
To display the LLDP Port Settings page, click System
LLDP Advanced LLDP Port
Settings.
To configure LLDP port settings:
1. Change
the LLDP port settings described below:
• In
terface. Specifies the port to be affected by these parameters.
• Admin S
tatus. Select the status for transmitting and receiving LLDP packets:
• Tx
Only: Enable only transmitting LLDP PDUs on the selected ports.
• Rx Only:
Enable only receiving LLDP PDUs on the selected ports.
• Tx
and Rx: Enable both transmitting and receiving LLDP PDUs on the selected
ports. This is the default value.
• Disabl
ed: Do not transmit or receive LLDP PDUs on the selected ports.
• Mana
gement IP Address. Choose whether to advertise the management IP address
from the interface. The possible field values are:
• S
top Advertise: Do not advertise the management IP address from the interface.
• Auto A
dvertise: Advertise the current IP address of the device as the
management IP address.
To Next Page
Loading...
