35
GS748T Smart Switch
4. If you change any of the network connection parameters, click Apply to apply the changes
to the system.
5. Click Canc
el to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
IPv6 Network Configuration
Use the IPv6 Network Configuration page to configure the IPv6 network interface, which is
the logical interface used for in-band connectivity with the switch via all of the switch's
front-panel ports. The configuration parameters associated with the switch's network
interface do not affect the configuration of the front-panel ports through which traffic is
switched or routed.
To access the page, click Syste
m Management IPv6 Network Configuration. A screen
similar to the following displays.
To access the switch over an IPv6 network, you must initially configure the switch with IPv6
information (IPv6 prefix, prefix length, and default gateway). IPv6 can be configured using
any of the following options:
• I
Pv6 Auto Configuration
• DHCPv6
When in-band connectivity is established, IPv6 information
can be changed using any of the
following:
• SNMP-b
ased management
• W
eb-based management
To Next Page
Loading...
