NETGEAR GS748T User Manual

36
GS748T Smart Switch
To configure the network information for an IPv6 network:
1. Admin Mode. Enable or disable the IPv6 network interface on the switch. The default
value is Enable.
2. IPv6 Address Auto Configuration Mode. The IPv6 address for the IPv6 network interface
is set in auto configuration mode if this option is enabled. The default value is Disable. Auto
configuration can be enabled only when DHCPv6 is not enabled on any of the management
interfaces.
3. Current Network Configuration Protocol. The IPv6 address for the IPv6 network interface
is configured by DHCPv6 protocol if this option is enabled. The default value is None.
DHCPv6 can be enabled only when IPv6 Auto config or DHCPv6 are not enabled on any of
the management interfaces.
4. DHCPv6 Client DUID. Identifier used to identify the client's unique DUID value. This option
only displays when DHCPv6 is enabled.
5. IPv6 Gateway. Specify the gateway for the IPv6 network interface. The gateway address is
in IPv6 global or link-local address format.
6. IPv6 Prefix/Prefix Length. Add the IPv6 prefix and prefix length to the IPv6 network
interface. The address is in the global address format.
7. EUI64. Specify whether format IPv6 address in EUI-64 format. The default value is False.
8. Click Add to add a new IPv6 address in global format.
9. Click Delete to delete a selected IPv6 address.
10. Click Apply to apply the changes to the system.
11. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
IPv6 Network Neighbor
Use the IPv6 Network Neighbor page to configure the IPv6 Network Interface IPv6 Neighbor
Tabl e.
To access the page, click System  Management  IPv6 Network Neighbor. A screen similar
to the following displays.

NETGEAR GS748T Specifications

General

Basic switching RJ-45 Ethernet ports quantity	48
MAC address table	16000 entries
Packet buffer memory	1.632 MB
Maximum data transfer rate	1 Gbit/s
Latency	20 µs
I/O ports	48 RJ-45 connectors for 10BASE-T, 100BASE-TX, and 1000BASE-T (Auto Uplink on all ports) 4 SFP slots for fiber Gigabit Ethernet modules
Dimensions (WxDxH)	440 x 260 x 43 mm
Power requirements	100-240VAC 50/60 Hz
Networking features	10BASE-T, 100BASE-TX, 1000BASE-T
Connectivity technology	Wired
Full duplex	Yes
Networking standards	IEEE 802.3x
Minimum system requirements	Category 5 network cables Network card for each PC Network software (e.g., Windows)
Mean time between failures (MTBF)	69930 h
Safety	UL listed (UL 1950)/cUL, IEC950/EN60950
LED indicators	Link, Power
Power consumption (typical)	70 W
Storage temperature (T-T)	-10 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Weight	4000 g