NETGEAR GS748T - Page 162

162
GS748T Smart Switch
• Source IPv6 Prefix/Length - This is a valid Source IPv6 Prefix to compare against an
IPv6 Packet. Prefix is always specified with the Prefix Length. Prefix can be entered in
the range of ::0 to FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF and Prefix Length
can be entered in the range of 0 to 128.
• Source L4 Port - This lists the keywords for the known source layer 4 ports from
which one can be selected. The list includes 'other' as an option for the unnamed
ports.
• Destination IPv6 Prefix/Length - This is a valid Destination IPv6 Prefix to compare
against an IPv6 Packet. Prefix is always specified with the Prefix Length. Prefix can
be entered in the range of ::0 to FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF and
Prefix Length can be entered in the range of 0 to 128.
• Destination L4 Port - This lists the keywords for the known destination layer 4 ports
from which one can be selected. The list includes 'other' as an option for the unnamed
ports.
• IP DSCP - This lists the keywords for the known DSCP values from which one can be
selected. The list includes 'other' as an option for the remaining values.
• Flow Label - This is a 20-bit number that is unique to an IPv6 Packet, used by end
stations to signify Quality of Service handling in routers. Flow Label can be specified
in the range of (0 to 1048575).
5. Click CANCEL to cancel the configuration on the screen. Resets the data on the screen to
the latest value of the switch.
6. Click APPLY to send the updated configuration to the switch. Configuration changes take
effect immediately.