NETGEAR GS748T User Manual

175
GS748T Smart Switch
Accounting Server Configuration
Use the RADIUS Accounting Server Configuration page to view and configure various
settings for one or more RADIUS accounting servers on the network.
To access the RADIUS Accounting Server Configurati
on page, click Security  Management
Security
 RADIUS  Accounting Server Configuration.
To configure the RADIUS accounting server:
1. I
n the Accounting Server Address field, specify the IP address of the RADIUS
accounting server to add.
2. In the Po
rt field, specify the UDP port number the server uses to verify the RADIUS
accounting server authentication. The valid range is 0–65535.
3. From the Se
cret Configured menu, select Yes to add a RADIUS secret in the next field.
You must select Yes before you can configure the RADIUS secret. After you add the
RADIUS accounting server, this field indicates whether the shared secret for this server has
been configured.
4. In the Sec
ret field, type the shared secret to use with the specified accounting server.
5. From the Accounting Mode
menu, enable or disable the RADIUS accounting mode.
6. Click App
ly to update the switch with the RADIUS Accounting server settings.
7. T
o delete a configured RADIUS Accounting server, click Delete.
8. Click Canc
el to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.

NETGEAR GS748T Specifications

General

Basic switching RJ-45 Ethernet ports quantity	48
MAC address table	16000 entries
Packet buffer memory	1.632 MB
Maximum data transfer rate	1 Gbit/s
Latency	20 µs
I/O ports	48 RJ-45 connectors for 10BASE-T, 100BASE-TX, and 1000BASE-T (Auto Uplink on all ports) 4 SFP slots for fiber Gigabit Ethernet modules
Dimensions (WxDxH)	440 x 260 x 43 mm
Power requirements	100-240VAC 50/60 Hz
Networking features	10BASE-T, 100BASE-TX, 1000BASE-T
Connectivity technology	Wired
Full duplex	Yes
Networking standards	IEEE 802.3x
Minimum system requirements	Category 5 network cables Network card for each PC Network software (e.g., Windows)
Mean time between failures (MTBF)	69930 h
Safety	UL listed (UL 1950)/cUL, IEC950/EN60950
LED indicators	Link, Power
Power consumption (typical)	70 W
Storage temperature (T-T)	-10 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Weight	4000 g