NETGEAR GSM7228PS - Page 123

Chapter 10. ACLs | 123
ProSafe 7000 Managed Switch Release 8.0.3
• In the IP Address field, enter 192.168.100.1.
• In the Network Mask field, enter 255.255.255.0.
c. Click Unit 1. The ports display.
d. Click the gray box under port 13 twice until U displays. The U specifies that the
egress packet is untagged for the port.
e. Click Apply to save VLAN 100.
3. Create VLAN 200 with IP address 192.168.200.1/24.
a. Select Routing > VLAN > VLAN Routing Wizard. A screen similar to the following
displays.
b. Enter the following information:
• In the Vlan ID field, enter 200.
• In the IP Address field, enter 192.168.200.1.
• In the Network Mask field, enter 255.255.255.0.
c. Click Unit 1. The ports display.
d. Click the gray box under port 44 twice until U displays. The U specifies that the
egress packet is untagged for the port.
e. Click Apply to save VLAN 200.
4. Enable IP routing.