Chapter 14. Security Management | 233
ProSafe 7000 Managed Switch Release 8.0.3
Web Interface: Configure a Protected Port to Isolate Ports on
the Switch
1. Create a DHCP pool:
Note: This example assumes that the DHCP service is enabled. For
information about how to enable the DHCP service, see the Web
interface procedure in Configure a DHCP Server in Dynamic Mode
on page 333.
a. Select System > Services > DHCP Server > DHCP Server Configuration. A screen
similar to the following displays.
b. Under DHCP Pool Configuration, enter the following information:
• In the Pool Name field, select Create.
• In the Pool Name field, enter pool-a.
• In the Type of Binding field, select Dynamic.
To Next Page
Loading...
