292 | Chapter 16. Tools
ProSafe 7000 Managed Switch Release 8.0.3
CLI: transport output telnet
(Netgear Switch Routing) (Config)#lineconfig ?
<cr> Press Enter to execute the command.
(Netgear Switch Routing) (Config)#lineconfig
(Netgear Switch Routing) (Line)#transport ?
input Displays the protocols to use to connect to a
specific line of the router.
output Displays the protocols to use for outgoing
connections from a line.
(Netgear Switch Routing) (Line)#transport output ?
telnet Allow or disallow new telnet sessions.
(Netgear Switch Routing) (Line)#transport output telnet ?
<cr> Press Enter to execute the command.
(Netgear Switch Routing) (Line)#transport output telnet
(Netgear Switch Routing) (Line)#
Web Interface: Configure Telnet
1. Select Security > Access > Telnet. A screen similar to the following displays.
To Next Page
Loading...
