NETGEAR GSM7228PS - Page 293

Chapter 16. Tools | 293
ProSafe 7000 Managed Switch Release 8.0.3
2. Under Outbound Telnet, for Admin Mode, select the Enable radio button.
3. Click Apply.
CLI: Configure the session-limit and session-timeout
(Netgear Switch Routing) (Line)#session-limit ?
<0-5> Configure the maximum number of outbound telnet sessions allowed.
(Netgear Switch Routing) (Line)#session-limit 5
(Netgear Switch Routing) (Line)#session-timeout ?
<1-160> Enter time in minutes.
(Netgear Switch Routing) (Line)#session-timeout 15
Web Interface: Configure the Session Timeout
1. Select Security > Access > Telnet. A screen similar to the following displays.
2. Enter the following information:
• In the Session Timeout field, enter 15.
• In the Maximum number of sessions field, enter 5.
3. Click Apply.