88 | Chapter 7. OSPF
ProSafe 7000 Managed Switch Release 8.0.3
a. Select Routing > OSPF > Advanced > Interface Configuration. A screen similar to
the following displays.
b. Scroll down and select the interface 2/0/19 check box. 2/0/19 now appears in the
Interface field at the top.
c. Enter the following information:
• In the OSPF Area ID field, enter 0.0.0.1.
• In the OSPF Admin Mode field, select Enable.
d. Click Apply to save the settings.
7. Configure area 0.0.0.1 as a nssa area.
a. Select Routing > OSPF > Advanced > NSSA Area Configuration. A screen similar
to the following displays.
b. Enter the following information.
• In the Area ID field, enter 0.0.0.1.
• In the Import Summary LSA’s field, select Disable.
c. Click Add to save the settings.
CLI: Configure Area 1 as an nssa Area on A2
1. Enable routing on the switch.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#router ospf
To Next Page
Loading...
