NETGEAR WAC505 - Page 112

This pane also contains a button that you can click to check for firmware updates for the access
point (see Check for New Firmware and Upgrade the Access Point on page 98).
• IP Settings Information pane.The IP Settings Information pane is in the center of the Dashboard
page (if the page width on your device is sufficient; otherwise, it might be elsewhere) and displays
the following:
- IP address of the access point and its DHCP status
- Gateway IP address
- Gateway status
- Wired traffic volume
5. To view more detailed information, select Management > Monitoring > System.
The page shows three sections:
• System Information section.The following settings are displayed:
- System Name. The access point NetBIOS name.
- System Mode. The access point system mode (AP).
- Ethernet MAC Address. The MAC address of the Ethernet port of the access point.
- Wireless MAC Address for 2.4 GHz.The MAC address of 2.4 GHz WiFi interface (radio) of
the access point.
- Wireless MAC Address for 5 GHz.The MAC address of 5 GHz WiFi interface (radio) of the
access point.
- Ethernet LLDP. The status of Ethernet LLDP feature (Enabled or Disabled).
- Country / Region.The country or region in which the access point operates or for which the
access point is licensed.
- Firmware Version. The version of the firmware that is installed on the access point.
Monitor the Access Point and the Network
112
Insight Managed Smart Cloud Wireless Access Point WAC505 User Manual