Factory Settings
You can reset the access point to the factory default settings, which are shown in the following table.
For more information about resetting the access point to its factory settings, see Return the Access Point
to Its Factory Default Settings on page 104.
Table 2. Access point factory default settings
Default SettingFeature
Access point login
Insight mode for the NETGEAR Insight appManagement mode
192.168.0.100User login URL
admin, nonconfigurableUser name (case-sensitive)
password, configurableLogin password
(case-sensitive)
General system settings
AP modeOperating mode
Enabled so that the access point receives an IP address from a DHCP
server in the network.
DHCP client
For products purchased in North America: Canada
For products purchased outside of North America: Germany
Country/region
EnabledNTP client
DisabledSpanning Tree Protocol
DisabledNetwork integrity check
Untagged VLAN with VLAN ID 1802.1Q VLAN
VLAN ID 1Management VLAN
DisabledSyslog
EnabledEthernet LLDP
EnabledUPnP
EnabledLEDs
WiFi network for initial setup
SSID for initial setup is NETGEARxxxxxx-SETUP, where xxxxxx is the last
six hexadecimal digits of the access point’s MAC address.
SSID name
WPA2-PSK
WiFi password (network key): sharedsecret
Security
Factory Default Settings and Technical Specifications
136
Insight Managed Smart Cloud Wireless Access Point WAC505 User Manual