4. Select Management > Configuration > IP > LAN.
5. Select the Enable radio button.
The fields are masked.
6. Click the Apply button.
Your settings are saved.The access point restarts with the new IP settings. It might take a while before
the access point receives its IP address setting from the DHCP server.
Set the 802.1Q VLAN and Management VLAN
The 802.1Q VLAN protocol on the access point logically separates traffic on the same physical (wired)
network. This protocol can work with tagged and untagged VLANs, as follows:
• Untagged VLAN. The access point sends untagged frames from its Ethernet interface. Incoming
untagged frames are assigned to the untagged VLAN. By default, the untagged VLAN is VLAN 1. By
default, the access point functions with an untagged VLAN.
• Tagged VLAN. The access point tags all frames that it sends from its Ethernet interface. Only the
incoming frames that are tagged with known VLAN IDs are accepted.
The management VLAN is used for managing traffic such as Telnet, SNMP, and HTTP traffic to and from
the access point. Frames that belong to the management VLAN and that are sent over the trunk do not
receive an 802.1Q header. If a port is a member of a single VLAN, its traffic can be untagged.
Manage the Local Area Network and IP Settings
85
Insight Managed Smart Cloud Wireless Access Point WAC505 User Manual