NETGEAR WAC505 - Page 114

4. Look at the Radio Information pane at the top, right corner of the Dashboard page (if the page width on
your device is sufficient; otherwise, it might be elsewhere). The following settings are displayed:
• Radio status (If the 2.4 GHz or 5 GHz icon is displayed as gray, the radio is turned off.)
• Mode
• Channel width
• Number of connected clients and maximum number of supported clients
• WiFi traffic volume
• Channel utilization
5. To view information for the 5 GHz radio, click the 5 GHz tab.
By default, information for the 2.4 GHz tab is shown.
6. To view more detailed information, including the MAC addresses of the WiFi radios, select Management
> Monitoring > System.
The page shows three sections:
• System Information section.The following settings are displayed:
- System Name. The access point NetBIOS name.
- System Mode. The access point system mode (AP).
- Ethernet MAC Address. The MAC address of the Ethernet port of the access point.
- Wireless MAC Address for 2.4 GHz.The MAC address of 2.4 GHz WiFi interface (radio) of
the access point.
- Wireless MAC Address for 5 GHz.The MAC address of 5 GHz WiFi interface (radio) of the
access point.
- Ethernet LLDP. The status of Ethernet LLDP feature (Enabled or Disabled).
Monitor the Access Point and the Network
114
Insight Managed Smart Cloud Wireless Access Point WAC505 User Manual