4. Select Management > Configuration > Security > RADIUS Settings.
5. For each RADIUS server that you want to set up, configure the following settings:
• IPv4 Address. Enter the IPv4 address of the RADIUS server. The access point must be able to
reach this IP address.
• Port. Enter the number of the UDP port on the access point that is used to access the RADIUS
server. For authentication servers, the default port number is 1812. For accounting servers, the
default port number is 1813.
• Password. Enter the password (shared key) that is used between the access point and
the RADIUS server during the authentication or accounting process. By default, the password is
sharedsecret.
6. Configure the following authentication settings, which apply to all RADIUS server that you set up:
• Reauthentication time. Enter the interval in seconds after which the supplicant (the WiFi client)
must be reauthenticated with the RADIUS server.The default interval is 3600 seconds (1 hour).
Enter 0 to disable reauthentication.
• Update Global Key. Select the check box to allow the global key update, and enter the interval in
seconds.The check box is selected by default, and the default interval is 1800 seconds (30 minutes).
Clear the check box to prevent the global key update.
7. Click the Apply button.
Your settings are saved.
Manage Access and Security
81
Insight Managed Smart Cloud Wireless Access Point WAC505 User Manual
To Next Page
Loading...
