Network Critical SmartNA-X - Et Authentication

103
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
COMMAND LINE INTERFACE REFERENCE |
DRAFT
SET AUTHENTICATION
Use the set authentication command to define the authentication method used to verify user login credentials. By
default, user accounts are authenticated locally, but you can use an authentication server to authenticate users by
choosing either RADIUS or TACACS+, as required by your authentication server. User accounts must be
administered on the authentication server, not locally, once RADIUS/TACACS authentication is enabled. Use the
create radius authserver or create tacacs authserver commands to specify the address of your authentication
server.
Command form set authentication {
Local | RADIUS | TACACS | locrad | loctac}
Examples
• Enable RADIUS authentication:
• Enable TACACS+ authentication:
• Enable local authentication:
{Local | RADIUS | TACACS
locrad
| loctac}
The following authentication methods are supported:
•
Local – authenticates users locally (this is the default).
•
RADIUS – authenticates users remotely via the configured RADIUS
authentication server
•
TACACS – authenticates users remotely via the configured TACACS+
authentication server
•
locrad – allows both local and RADIUS users to log in. This is intended to be used
while setting up a RADIUS server to ensure that the system administrator is not
locked out. Once RADIUS is working, authentication should be changed to
RADIUS.
•
loctac – allows both local and TACACS+ users to log in. This is intended to be
used while setting up a TACACS+ server to ensure that the system administrator is
not locked out. Once TACACS+ is working, authentication should be changed to
TACACS.
CONTROLLER>set authentication radius
Change accepted
CONTROLLER>set authentication tacacs
Change accepted
CONTROLLER>set authentication local
Change accepted