Network Critical SmartNA-X - Elete Radius Authserver

105
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
COMMAND LINE INTERFACE REFERENCE |
DRAFT
DELETE RADIUS AUTHSERVER
Use the delete RADIUS authserver command to remove access to a RADIUS authentication server. Note that
users will not be able to access SmartNA-X unless local authentication is enabled (set authentication local) or
another authentication server is added (create radius authserver).
Command form delete RADIUS authserver IP-addr
Example Delete RADIUS authentication server 192.168.10.22:
IP-addr Specifies the network IP address of the RADIUS authentication server.
CONTROLLER>delete radius authserver 192.168.10.22
removing RADIUS server