Network Critical SmartNA-X - Commands for Managing Port Maps and Packet Filters

128
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
COMMAND LINE INTERFACE REFERENCE |
DRAFT
SET PORT LOCK
Use the port set port lock command to configure port locking of the currently selected TAP module. Locking a
port will prevent access to unauthorized users. This command is also used to unlock a port that has been auto-
locked.
Command form set port port-id lock {
on | off}
Examples
• Enable port lock for port 4C:
• Disable port lock for port 4D:
port-id Specifies the port to set. Front ports are labelled A to D, left to right, and rear ports
are labelled A and B. Only one port can be set at a time.
on | off Sets the port lock to on or off. Off is the default setting for all ports.
SLOT4>set port C lock on
SLOT4>show port C
speed : set 1G
duplex : set auto actual full
mdi : set mdi-x
mastering : set preferslave
tap : off
autolock : on
lock : on
usage : undefined
port type : Registered Jack 45 (RJ45)
PORT DOWN
traffic threshold low : 10
traffic threshold high: 100
SLOT4>set port D lock off
SLOT4>show port D
speed : set auto
duplex : set auto actual full
mdi : set mdi
mastering : set preferslave
tap : off
autolock : off
lock : off
usage : undefined
port type : Registered Jack 45 (RJ45)
PORT DOWN
traffic threshold low : 0
traffic threshold high: 100