45
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
CONFIGURING PORTS | SAVING PORT SETTINGS
DRAFT
The following example session enables autolock on ports 2A and 2B:
Saving port settings
Once you have configured your ports, you may want to save your settings so they can be retrieved quickly at a later
date. You can do this through the web UI, by selecting the
Management tab and choosing Save current
configuration (see
Figure 6-3), or through the CLI with the create settings name command. Saving a
CONTROLLER>select slot 2
SLOT2>set port a autolock on
SLOT2>set port b autolock on
SLOT2>show port a
speed : set auto
duplex : set auto
mdi : set auto
mastering : set preferslave
tap : off
autolock : on
lock : on
usage : undefined
port type : Registered Jack 45 (RJ45)
PORT DOWN
traffic threshold low : 0
traffic threshold high: 100
SLOT2>show port b
speed : set auto
duplex : set auto
mdi : set auto
mastering : set preferslave
tap : off
autolock : on
lock : off
usage : undefined
port type : Registered Jack 45 (RJ45)
PORT DOWN
traffic threshold low : 0
traffic threshold high: 100
SLOT2>
To Next Page
Loading...
