126
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
COMMAND LINE INTERFACE REFERENCE |
DRAFT
SET PORT TAP
Use the set port tap command to configure the specified ports as TAP ports of the currently selected TAP module.
TAP ports connect to the live network and as such must provide link-up status at all times. In the event of a power
failure or a module being pulled, a relay switch is instantly closed to maintain the network connection when TAP
is on. TAP off can be used when connecting to network tools, to prevent data being captured when a module is
pulled or when a general port failure has occurred.
Command form set port port-id tap {
on | off}
Example Enable TAP mode for port 4C:
port-id Specifies the port to set. Front ports are labelled A to D, left to right, and rear ports
are labelled A and B. Only one port can be set at a time.
on | off Sets the TAP mode to on or off. Off is the default setting for ports.
CONTROLLER>select slot 4
SLOT4>set port C tap on
SLOT4>show port C
speed : set 1G
duplex : set auto actual full
mdi : set mdi-x
mastering : set preferslave
tap : on
autolock : off
lock : off
usage : undefined
port type : Registered Jack 45 (RJ45)
PORT DOWN
traffic threshold low : 10
traffic threshold high: 100
To Next Page
Loading...
