Network Critical SmartNA-X - Et Port Trafficlow

131
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
COMMAND LINE INTERFACE REFERENCE |
DRAFT
SET PORT TRAFFICLOW
Use the port set port trafficlow command to set the low traffic thresholds used by SNMP to trigger a health
notification.
Command form set port port-id trafficlow {0...100}
Example Set a traffic low threshold of 10% for port 4C:
port-id Specifies the port to set. Front ports are labelled A to D, left to right, and rear ports
are labelled A and B. Only one port can be set at a time.
SLOT4>set port C trafficlow 10
SLOT4>show port C
speed : set 1G
duplex : set auto actual full
mdi : set mdi-x
mastering : set preferslave
tap : off
autolock : on
lock : off
usage : undefined
port type : Registered Jack 45 (RJ45)
PORT DOWN
traffic threshold low : 10
traffic threshold high: 100