152
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
COMMAND LINE INTERFACE REFERENCE |
DRAFT
Commands for managing SNMP
This section describes the SNMP commands that are used to view, create and delete SNMP related configurations.
Commands are entered in the SmartNA-X command-line interface and require Administrator access to run.
For security, the SNMP agent is disabled on SmartNA-X by default. Although you can still configure SNMP
notifications, users, views and groups, you’ll need to enable the agent to expose management data and send
notifications. To enable the SNMP agent, enter the following commands:
To confirm the agent is enabled, use this command:
If you need to disable the agent, use this command:
The CLI supports the following SNMP commands:
• SNMP basic commands, page 153
• SNMP notify commands, page 158
• SNMPv1/v2c commands, page 164
• SNMP View-based Access Control Module (VACM) commands, page 170
CONTROLLER>snmp enable agent
CONTROLLER>snmp show agent
SNMP : Enabled
CONTROLLER>snmp disable agent
CONTROLLER>snmp show agent
SNMP : Disabled
To Next Page
Loading...
