Network Critical SmartNA-X - How Port

121
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
COMMAND LINE INTERFACE REFERENCE |
DRAFT
SHOW PORT
Use the show port command to display port information.
Command form show port port-id
Example Show settings for port 4A:
CONTROLLER>select slot 4
SLOT4>show port A
speed : set auto actual 1G
duplex : set auto actual full
mdi : set auto actual mdi-x
mastering : set preferslave actual slave
tap : on
autolock : off
lock : off
usage : undefined
port type : Registered Jack 45 (RJ45)
PORT UP
traffic threshold low : 0
traffic threshold high: 100