Network Critical SmartNA-X - Commands for Managing TAP Ports

114
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
COMMAND LINE INTERFACE REFERENCE |
DRAFT
Commands for managing TAP ports
The CLI supports the following commands for managing TAP ports:
• SHOW PORT, page 121
• SET PORT SPEED, page 122
• SET PORT DUPLEX, page 123
• SET PORT MDI, page 125
• SET PORT TAP, page 126
• SET PORT AUTOLOCK, page 127
• SET PORT LOCK, page 128
• SET PORT MASTERING, page 129
• SET PORT TRAFFICLOW, page 131
• SET PORT TRAFFICHIGH, page 132