Network Critical SmartNA-X - Et Port Speed

122
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
COMMAND LINE INTERFACE REFERENCE |
DRAFT
SET PORT SPEED
Use the set port speed command to configure the speed of the specified copper port (A–D) of the selected TAP
module. Setting anything other than Auto fixes the port at the specified setting, even if the link partner is unable to
communicate at that setting or if network transmission conditions deteriorate. Note that SFP/SFP+ and fiber
channel ports do not support port speed variance.
Command form set port port-id speed {
Auto 10M | 100M | 1G | 10G}
Example Set port 4C to 1 Gbit/s:
Set slot 4 port D to auto speed:
port-id Specifies the port to set. Front ports are labelled A to D, left to right, and rear ports
are labelled A and B. Only one port can be set at a time.
Auto 10M | 100M | 1G |
10G
Sets the port speed to auto negotiate, 10 Mbit/s, 100 Mbit/s, 1 Gbit/s, or
10 Gbit/s. Use
Auto (the default) to let the system auto-negotiate the optimum port
speed and automatically adjust speed if link conditions change. Setting a fixed speed
(10M, 100M, 1G or 10G) will fix the port at that speed, regardless of line
conditions or link partner.
CONTROLLER>select slot 4
SLOT4>set port C speed 1G
SLOT4>show port C
speed : set 1G
duplex : set auto
mdi : set mdi-x
mastering : set preferslave
tap : off
autolock : off
lock : off
usage : undefined
port type : Registered Jack 45 (RJ45)
PORT DOWN
traffic threshold low : 10
traffic threshold high: 100
CONTROLLER>select slot 4
SLOT4>set port D speed auto
SLOT4>show port D
speed : set auto
duplex : set auto
mdi : set auto
mastering : set preferslave
tap : on
autolock : off
lock : off
usage : undefined
port type : Registered Jack 45 (RJ45)
PORT DOWN
traffic threshold low : 0
traffic threshold high: 100