32
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
ADMINISTERING SMARTNA-X | REBOOTING THE SYSTEM
DRAFT
Uploading a new configuration
CAUTION: Uploading invalid configuration data can render your hardware inoperable.
1. Within the management tab, select Upload configuration and click Continue to log out of the system in
readiness for uploading the new configuration.
2. Enter the SmartNA-X administrator username and password.
3. Navigate to the configuration file you want to upload. Please upload only configuration files you have
previously downloaded from a SmartNA-X device.
4. Click Upload new configuration.
Rebooting the system
Rebooting the system may occasionally be required in order to refresh the SmartNA-X system and return all
configuration settings to the last saved/applied settings. During the rebooting, users will not be able to access the
system and any users logged in will be automatically logged out.
Note the following impact on TAPs during a reboot:
• Copper ports with TAP mode configured will continue to pass traffic, although there will be a momentary break
in transmission while port relays are activated. The relays will be de-activated once the system is fully rebooted.
See the
“Configuring port failsafe and LFP (TAP mode)” section on page 40 for details of how to enable TAP
mode on copper ports.
• Optical ports (SFP and fiber) will continue to pass traffic throughout the reboot, with no break in transmission
• Tapped traffic will not be copied to output/monitoring ports while the system is rebooting
• Any counters that are running will not be updated during rebooting
Using the web UI to reboot the system
1.
Log in to the web UI.
2. Click on the main chassis area to access system management settings.
3. Select the Management tab.
4. Click Reboot, and then click Reboot again to confirm.
After a short delay, the system will reboot and log you out of the web UI.
Using the web UI to reboot the system
Enter the following command to reboot the system:
Updating system firmware
Network Critical periodically may release new firmware updates to introduce new features and update system
functionality. For the latest firmware updates, contact Network Critical at
support@networkcritical.com.
CONTROLLER>reboot
To Next Page
Loading...