Network Critical SmartNA-X - System Identity Tab

185
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
COMMAND LINE INTERFACE REFERENCE |
DRAFT
SNMP DELETE ACCESS
Use the snmp delete access command to delete the specified access group.
SNMP
SNMPv3
Command form snmp delete access group-name {any | usm | v1 | v2c} {noAuth | auth | priv} {read-viewname}
{write-viewname} {notify-viewname}
Example Delete the access group named group2 with any SNMPv1/v2c and USM security and no authorization security:
group-name Specifies the name of the group.
{
any | usm | v1 | v2c} Specifies the security model. Since the same group can have multiple access
commands defined, each with a different security model, this limits deletion to the
group with the specified security model, or all models if
all is specified.
noAuth | auth | priv} Specifies the security model. Since the same group can have multiple access
commands defined, each with a different see model, this limits deletion to the group
with the specified security level.
read-viewname Specifies the view to which get requests are mapped.
write-viewname Specifies the view to which set requests are mapped.
notify-viewname Specifies the view to which notify requests are mapped.
CONTROLLER>snmp delete access group2 any noAuth