72
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
COMMAND LINE INTERFACE REFERENCE |
DRAFT
SELECT
Use the select command to select the system Controller (motherboard) or a chassis slot. Selecting a slot will give
you access to the TAP module that is installed in the slot and allow you to view and configure its ports.
Command form select slot [0-4]
select controller
Examples
• Select slot 1 (left slot):
• Select slot 0 (rear ports):
• Select Controller:
SlotNumber Specifies the chassis slot number. Front slots are numbered 1–4 (left to right); rear
ports are slot 0.
CONTROLLER>select slot 1
SLOT1>
CONTROLLER>select slot 0
SLOT0>
SLOT1>select controller
CONTROLLER>
To Next Page
Loading...
