77
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
COMMAND LINE INTERFACE REFERENCE |
DRAFT
REBOOT
Use the reboot command to restart the current TAP module or the system motherboard when Controller is
selected. Rebooting the Controller/motherboard will log you out of the system and prevent connectivity for several
minutes. A TAP mode link on the live network should not be affected more than momentarily by a reboot, but
traffic passing through the link will not be copied to other ports during the reboot time. Counters will not be
updated until the reboot process has completed.
Command form reboot
Examples
• Reboot slot 0 (rear ports):
• Reboot system motherboard:
CONTROLLER>select slot 0
SLOT 0>reboot
CONTROLLER>reboot
Rebooted card 0
Rebooted card 1
Rebooted card 2
Rebooted card 3
Rebooted card 4
Rebooted motherboard
CONTROLLER>
Broadcast message from root@SNAE-v2-122 (Sun Aug 5 15:44:00 2012):
The system is going down for reboot NOW!
Connection to 192.168.0.122 closed by remote host.
Connection to 192.168.0.122 closed.
admin@example.com:~$
To Next Page
Loading...
