90
S
MARTNA™ 10G NETWORK ACCESS (SMARTNA-X)
COMMAND LINE INTERFACE REFERENCE |
DRAFT
SET IPV4 DHCP
Use the set ipv4 dhcp command to enable DHCP and have your DHCP server automatically assign network
settings, including IP address, gateway and DNS, to SmartNA-X. The new configuration is not implemented until
you log out (exit) from the CLI when accessing through the current (static) IPv4 address. The requirement to exit
the CLI does not apply if DHCP is enabled through the Console/Serial port or IPv6, and in these cases the
configuration will be implemented instantly.
Command form set ipv4 dhcp
Example Enable DHCP and exit to enable new network settings:
CONTROLLER>set ipv4 dhcp
Network settings will take effect when you exit CLI.
exit to enable new network settings
CONTROLLER>exit
To Next Page
Loading...
