7 Press “Circuit Check” button on LCD touch screen, and
“
Circuit Check Test in Progress
” massage appears on LCD
touch screen as shown in Figure 2-16.
8 When circuit test is completed successfully, “
Circuit Check
PASSED
” message appears on LCD touch screen.
9 If circuit test failed, “
Circuit Check FAILED
” message
appears on LCD touch screen. Please check the breathing
circuit for leaks and press “
Circuit Check” button on LCD
touch screen and repeat Circuit Check. If circuit check does
not pass, please contact NMI representative for further
assistant.
10 Press “Setup & Calibration” button on the Control Panel.
1
1
Press “TECHNICAL” button on LCD touch screen, see Figure
2-17.
12 Press “Regional Settings” button on LCD touch screen, see
Figure 2-17.
13 Press “Altitude” button on LCD touch screen and “_ ft/_ m”
setting will start flashing.
14 While the numbers are flashing, rotate the Encoder
Adjustment Knob to change the Altitude level to where this
instruction is going to be performed. (For example if the
location is at the sea level, then set Altitude setting to “
0 m / 0
ft
”).
15 Press “Accept” button to set the new Altitude setting and
flashing will stop.
16 Wait for 15 ~ 20 seconds.
17 Turn “OFF” the power of the e360 ventilator.
18 Press and hold “Accept” button and then turn “ON” the
power of the e360 ventilator to enter into Software Download
screen on the e360 ventilator shown in Figure 2-11. “
Accept”
button can be released once the ventilator sounds a short
beep.
19 Press “Start Diagnostics” button on LCD touch screen and
the Diagnostic Data screen will appear as shown in Figure 2-
18.
20 Press “Trig Button” on the Control Panel. Rotate the Encoder
Adjustment Knob to change value in display window to “d9”
and press “
Accept” button.
21 Occlude the breathing circuit from the y-piece using a CAP
.
(
Do not use test lung).
MAINTENANCE, OVERHAUL & SOFTWARE UPGRADE
2-14 SER360 A1106
To Next Page
Loading...
