Newport MM4005 - Remote Control Connector (15-Pin D-Sub)

EDH0162En1040 – 06/99 8.10
MM4005 Appendix C — Connector Pinouts
C.3 Remote Control Connector (15-pin D-Sub)
This connector should only be used with the NEWPORT RC4000 remote
Controller.
The connector also provides an Emergency Stop switch input with identi-
cal operation to the one in the Power Inhibition connector. If no remote
controller are used, the pins must be shorted.
Pin # Description
1
— DGND
2 — I
}
For normal operation connect pins 2 and 3 together.An
open circuit is equivalent to pressing the MOTOR on
the front panel.
3 — O
4 — UTIL
5 — UTIL
6 — UTIL
7 — UTIL
8 — UTIL
9 — DGND
10 — DGND
11 — UTIL
12 — UTIL
13 — UTIL
14 — UTIL
15 — UTIL
WARNING
NEWPORT assumes no responsability for the use of any other Remote
Controller.
OFF
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com