NewSonic SonoDur2 Issue 04 09/2016 Page 12
2.2 Safety Information
The SonoDur2 is manufactured and tested in accordance with the applicable safety regulations (EN
60950-1:2006, EC Low Voltage Directive) and has left the factory in a safety-related flawless
condition. In order to maintain this condition and to ensure safe operation, please make sure you
read the following safety information before you start using the device:
UCI hardness measuring probes are highly accurate precision measurement instruments
which may not, under any circumstances, be exposed to shocks or impact load!
The device must be exclusively used for material testing, other applications, e.g. medical
applications are not allowed!
Keep measurement devices and accessories out of children’s reach!
The SONO-NG plug-in power supply unit may be used in dry areas only! Please do not use a
power supply plug-in adaptor that is not approved for this product!
The test device and/or plug-in power supply may no longer be used and need to be secured
against unintentional commissioning, if
visible damages are apparent
the system no longer works properly
the device had been under extraordinary transportation stress
after prolonged storage under extremely unfavorable environmental conditions
(temperature/humidity)
Store and operate the test device and accessory only in the specific environmental conditions
(temperature/humidity)!
When used in commercial facilities, the accident prevention regulations of the professional
trade association for electrical installations and equipment must be observed.
Repairs may only be performed by authorized specialist staff.
Never turn on the device/power supply unit, if the device/accessory is moved from a cold to
a warm area. The generated condensation water may damage the device/accessory under
unfavorable conditions! Leave the device/equipment switched off before it has been
adjusted to room temperature.
2.3 Meaning of “Attention” and “Please note”
Attention:
Ignoring these important facts can potentially lead to severe consequences.
Please note
Information provided to make your work easier and to improve results.
Your Complete Source for
Testing Equipment. Since 1969!
www.BergEng.com
Berg Engineering & Sales Company, Inc.
Tel 847-577-3980
info@bergeng.com
To Next Page
Loading...