NewSonic SonoDur2 - Delete Adjustment

NewSonic SonoDur2 Issue 04 09/2016 Page 36
The SonoDur2 then asks, if the adjustment number should be used for the actual measurement set,
or if a new test series should be started. By answering “No” all actual measurement values will be re-
calculated with the new adjustment value.
Figure 7.49
Figure 7.50
By answering “Yes”, the instrument queries if the actual measurement set should be stored or not. If
“Yes” the “Store File” menu opens and after storing the measurement set, a new test series will be
initialized.
7.7.3 Delete Adjustment
By executing via the “Forward”-button, the adjustment number will be set back to 0 = low alloy steel,
if a adjustment exists (Figure 7.52).
Please note:
If a different material than low alloy steel (A1) is chosen (for example F5 with its corresponding
adjustment number), the adjustment is not deleted but in case recessed to the initial value.
Figure 7.51
Figure 7.52
Your Complete Source for
Testing Equipment. Since 1969!
www.BergEng.com
Berg Engineering & Sales Company, Inc.
Tel 847-577-3980
info@bergeng.com