ACCESS GATEWAY
System Administration 265
5. Click on the Add button to add your entry, or click on the Reset button if you want to reset
all the values to their previous state.
Deleting an ARP Table Entry {ARP Delete}
Note: NSE releases 8.2 and later consolidate ARP operations to a single screen. See Adding
and Deleting ARP Table Entries.
ARP (Address Resolution Protocol) is used to dynamically bind a high level IP address to a
low level physical hardware (MAC) address. ARP is limited to a single physical network that
supports hardware broadcasting. This procedure shows you how to delete an ARP table entry.
1. From the Web Management Interface, click on System, then ARP Delete. The Delete
ARP Table Entries screen appears:
2. Enter the IP address of the entry you want to delete.
3. Click on the Delete button to delete this entry, or click on the Reset button if you want to
reset the “IP Address” value to its blank state.
Adding and Deleting ARP Table Entries
NSE releases 8.2 and later consolidate the ARP interface. You can add or delete table entries
from a single screen.
To Next Page
Loading...
