ACCESS GATEWAY
Installing the Access Gateway 61
Enter new system location: Office, Newbury Park, CA
Enter read/get community [public]:
Enter write/set community [private]:
Enter IP of trap recipient [0.0.0.0]: 10.11.12.13
SNMP Daemon: Enabled
System contact: newname@domainname.com
System location: Office, Newbury Park, CA
Get (read) community: public
Set (write) community: private
Trap recipient: 10.11.12.13
Reboot to enable new changes? [yes/no] y
Rebooting...
You can now address the Access Gateway using an SNMP client manager.
Configuring the WAN interface
NSE releases 8.2 and later add the following configuration steps.
If a license key is not present, you will still be directed to set up the WAN configuration as
soon as you log into the CLI.However, the subsequent steps are new and network settings are
no longer configured under Location.
The following are the steps are needed to configure the main WAN interface:
1. Enter c (configuration) at the Access Gateway Menu. The Configuration menu appears.
2. Enter eth (ethernet).
1. After you have entered “yes” to the initial prompt, enter “mod int WAN” or “m i WAN”
(“modify interface WAN”). Note that modes and interface names are case sensitive. The
configuration then steps through the settings one by one.
2. Port role for the WAN port should be already set to WAN, just hit <enter>
3. Set the configuration mode to match your network settings.
4. Set the remaining network settings .
5. Default uplink and download speed is 15 Mbps. Enter different values if desired.
In NSE releases 8.2 and later, bandwidth and DNS settings are configured separately for
each WAN interface. You can configure them later in the WAN configuration dialog in the
Web Management Interface.
6. If you do not wish to configure additional NAT IP addresses at this time, type “b”.
7. A summary of the WAN port settings is now displayed; if they are correct, type “b” again.
To Next Page
Loading...
