ACCESS GATEWAY
286 System Administration
1. From the Web Management Interface, click on System, then Subscriber Interfaces. The
Subscriber Interfaces screen appears:
2. Enable or disable your choice of Block Wired Subscriber Interfaces.
3. Click on the Submit button to save your changes, or click on the Reset button to reset all
values to their previous state.
Updating the Access Gateway Firmware {Upgrade}
Upgrading the Access Gateway firmware is performed from the Access Gateway’s Command
Line Interface (CLI) only. Refer to the Firmware Upgrade Procedure (separate document
available from Nomadix Technical Support).
To Next Page
Loading...
