Nomadix Access Gateway - Accessory Box Contents; Start here

ACCESS GATEWAY
44 Installing the Access Gateway
This quick start document provides instructions and reference material for getting started
with the Nomadix Access Gateway products, specifically the AG 2400 and AG 5800.
Accessory Box Contents
AG 2400
1 – U.S. (NEMA 5-15p) Power Cord
1 – EU (Schuko CEE7/7) Power Cord
1 – 6’ RJ45 – DB9 Console Cable
2 – Rack Mount Brackets and PS bracket
1 – Bumper and Screw Kit
AG 5800
1 – U.S. (NEMA 5-15p) Power Cord
1 – EU (Schuko CEE7/7) Power Cord
1 – 6’ RJ45 – DB9 Console Cable
2 – Rack Mount Brackets
1 – Bumper and Screw Kit
Start Here
1. Unpack the Nomadix Access Gateway and place the product on a flat and stable work
surface.
2. Register the gateway for support services by completing and returning the Nomadix
Gateway Registration Form; hardcopy enclosed or obtain the form online at
http://www.nomadix.com/registration
.
3. Connect the power cord.
4. Connect to the Access Gateway (AG). There are two ways to connect to the Access
Gateway (AG):
 Serial Connection:
Connect the RJ45 console cable to the product’s console port and the DB9 female to your
computer.