ACCESS GATEWAY
112 System Administration
5. To enable parameter passing, click on the Parameter Passing Enable check box.
6. Select the Parameter Signing:
Method:
None, HASH-CRC32, or HMAC-MD5 (select one method).
Parameters:
UI, MA, RN, PORT, and SIP (select all applicable parameters). (SIP was removed in
NSE releases 8.2 and later).
7. To enable Set Shared Secret, click on the Set Shared Secret check box. If you enable this
feature, enter the shared secret text string in the
Set Shared Secret field.
8. Click on the Submit button to save the redirection settings, or click on the Reset button if
you want to reset all the values to their previous state.
Portal page setting are saved to the table in
Existing Portal Page entries section of the
screen. From that table, you can edit or delete existing portal pages
Managing the DHCP service options {DHCP}
When a device connects to the network, the DHCP server assigns it a “dynamic” IP address for
the duration of the session. Most users have DHCP capability on their computer. To enable this
service on the Access Gateway, you can either enable the DHCP relay (routed to an external
DHCP server IP address), or you can enable the Access Gateway to act as its own DHCP
server. In both cases, DHCP functionality is necessary if you want to automatically assign IP
addresses to subscribers.
To Next Page
Loading...
