Installation
3-36
Part 1120277_01
E 2012 Nordson Corporation
Installing Melter Inputs (contd)
To set up a digital input
Set up the parameter control option for each input that you connected to the
melter. Table 3-8 lists the available control options. Refer to Setting Up the
Melter earlier in this section, for information about how to select operating
parameters and edit parameter control options.
With the exception of the pump
enable/disable control option, all inputs
are transition-based.
Input Setup in Appendix B
The input capacity of the m elter m ay be
increasedfromfourinputstoatotalof
ten inputs by adding an optional I/O
expansion card that is available from
Nordson Corporation.
Section 7, Parts
To Next Page
Loading...
