Nortel BCM50a - Figure 37 Menu 15.2 - NAT Server Sets

100 Chapter 9 Network Address Translation (NAT)
N0115791
Figure 37 Menu 15.2 – NAT Server Sets
3 Select Edit Rule in the Select Command field; type the index number of the
NAT server you want to configure in the Select Rule field and press
[ENTER] to open Menu 15.2.1 - NAT Server Configuration (see the next
figure).
Menu 15.2 - NAT Server Setup
Default Server: 0.0.0.0
Rule Act. Start Port End Port IP Address
------------------------------------------------------
001 No 0 0 0.0.0.0
002 No 0 0 0.0.0.0
003 No 0 0 0.0.0.0
004 No 0 0 0.0.0.0
005 No 0 0 0.0.0.0
006 No 0 0 0.0.0.0
007 No 0 0 0.0.0.0
008 No 0 0 0.0.0.0
009 No 0 0 0.0.0.0
010 No 0 0 0.0.0.0
Select Command= None Select Rule= N/A
Press ENTER to Confirm or ESC to Cancel: