Nortel BCM50a - Figure 18 Menu 11.1 - Remote Node Profile; Table 12 Menu 11.1 Remote Node Profile

72 Chapter 6 Remote Node setup
N0115791
Selecting RFC-1483 encapsulation with VC-based multiplexing requires the
least amount of overhead (0 octets). However, if there is a potential need for
multiple protocol support in the future, it may be safer to select PPPoA
encapsulation instead of RFC-1483, so you do not need to reconfigure either
computer later.
• Scenario 3.Multiple VCs
If you have an equal number (or more) of VCs than the number of protocols,
then select RFC-1483 encapsulation and VC-based multiplexing.
Figure 18 Menu 11.1 – Remote Node Profile
Table 12 describes fields in Figure 18.
Menu 11.1 - Remote Node Profile
Rem Node Name= ChangeMe Route= IP
Active= Yes Bridge= No
Encapsulation= ENET ENCAP Edit IP/Bridge= No
Multiplexing= LLC-based Edit ATM Options= No
Service Name= N/A Edit Advance Options= N/A
Incoming: Telco Option:
Rem Login= N/A Allocated Budget(min)= N/A
Rem Password= N/A Period(hr)= N/A
Outgoing: Schedule Sets= N/A
My Login= N/A Nailed-Up Connection= N/A
My Password= N/A Session Options:
Authen= N/A Edit Filter Sets= No
Idle Timeout(sec)= N/A
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.
Table 12 Menu 11.1 Remote Node Profile
Field Description Example
Rem Node
Name
Type a unique, descriptive name of up to eight characters
for this node.
myISP
Active Press [SPACE BAR] and then [ENTER] to select Yes to
activate or No to deactivate this node. Inactive nodes are
displayed with a minus sign “–“ in SMT menu 11.
Yes