Nortel BCM50a - Syslog logging

152 Chapter 14 System information and diagnosis
N0115791
Figure 75 Menu 24.3 – System Maintenance: Log and Trace
Syslog logging
The BCM50a Integrated Router uses the syslog facility to log the CDR (Call
Detail Record) and system messages to a syslog server. Syslog and accounting
can be configured in Menu 24.3.2 - System Maintenance - Syslog Logging, as
shown in Figure 76.
Figure 76 Menu 24.3.2 – System Maintenance: Syslog Logging
Configure the syslog parameters described in Table 32 to activate syslog, and then
choose what you want to log.
Menu 24.3 - System Maintenance - Log and Trace
2. Syslog Logging
4. Call-Triggering Packet
Press ENTER to Confirm or ESC to Cancel
Menu 24.3.2 - System Maintenance - Syslog Logging
Syslog:
Active= No
Syslog Server IP Address= ?
Log Facility= Local 1
Press ENTER to Confirm or ESC to Cancel
Table 32 System Maintenance Menu Syslog Parameters
Parameter Description
Syslog:
Active Press [SPACE BAR] and then [ENTER] to turn syslog on or off.