Chapter 3 WAN Setup 55
BCM50a Integrated Router Configuration — Advanced
Traffic redirect setup
Configure parameters that determine when the BCM50a Integrated Router
forwards WAN traffic to the backup gateway using Menu 2.2 - Traffic Redirect
Setup.
Edit Traffic
Redirect
Press [SPACE BAR] to select Yes or No.
Select No (default) if you do not want to configure this
feature.
Select Yes and press [ENTER] to configure Menu 2.2
— Traffic Redirect Setup.
No
Dial-Backup: Dial backup does not apply to all BCM50a Integrated
Router models.
Active Use this field to turn the dial-backup feature on (Yes)
or off (No).
No
Port Speed Press [SPACE BAR] and then press [ENTER] to
select the speed of the connection between the dial
backup port and the external device.
Available speeds are:
9600, 19200, 38400, 57600, 115200 or 230400 b/s.
115200
AT Command
String:
Init Enter the AT command string to initialize the WAN
device. Consult the manual of the WAN device
connected to your Dial Backup port for specific AT
commands.
at&fs0=0
Edit Advanced
Setup
To edit the advanced setup for the Dial Backup port,
move the cursor to this field; press the [SPACE BAR]
to select Yes and then press [ENTER] to go to Menu
2.1 — Advanced Setup.
Yes
After you complete this menu, press [ENTER] at the
prompt “Press ENTER to Confirm…” to save your
configuration, or press [ESC] at any time to cancel.
Table 6 Menu 2 WAN setup
Field Description Example
To Next Page
Loading...
