Nortel BCM50a - Nortel WLAN handsets 2210 & 2211 phone options; TFTP server IP address assignment

Appendix I Enhanced DHCP option commands 287
BCM50a Integrated Router Configuration — Advanced
This command sets DHCP option 191.
The following example sets the BCM50a Integrated Router to assign a VLAN ID of five
to VoIP telephones.
ip dhcp enif0 server vlanid 5
Nortel WLAN handsets 2210 & 2211 phone options
Nortel's WLAN Handsets 2210 & 2211 phones require the same options as the IP Phone
2004. In addition, use the commands in this section to add other site-specific options to
the to the DHCP server's offer messages that it sends to Nortel WLAN Handsets 2210 &
2211.
TFTP server IP address assignment
Syntax:
ip dhcp <interface> server tftpserver [none | <serverIP>]
where:
Use this command to assign a TFTP server IP address to Nortel WLAN Handsets 2210 &
2211s.
The following example sets the BCM50a Integrated Router to assign a TFTP server IP
address of 11.12.13.15 to WLAN Handsets 2210 & 2211.
ip dhcp <interface> server tftpserver 11.12.13.15
<interface>
Specify an interface on the device. Currently you can use this
command with the LAN interface (enif0).
none | <serverIP>
Specify the address of a TFTP server for the Nortel WLAN
Handsets 2210 & 2211.
Use “none” if you do not want the DHCP server to automatically
assign the IP address of a TFTP server for the Nortel WLAN
Handsets 2210 & 2211.