Nortel BCM50a - Configuring Trigger Port Forwarding; Figure 49 Example 3: Menu 15.2

Chapter 9 Network Address Translation (NAT) 111
BCM50a Integrated Router Configuration — Advanced
Figure 49 Example 3: Menu 15.2
Configuring Trigger Port forwarding
Enter 3 in menu 15 to display Menu 15.3 — Trigger Port Setup, shown in
Figure 50.
Menu 15.2 - NAT Server Setup
Default Server: 0.0.0.0
Rule Act. Start Port End Port IP Address
------------------------------------------------------
001 Yes 80 80 192.168.1.21
002 Yes 25 25 192.168.1.20
003 No 0 0 0.0.0.0
004 No 0 0 0.0.0.0
005 No 0 0 0.0.0.0
006 No 0 0 0.0.0.0
007 No 0 0 0.0.0.0
008 No 0 0 0.0.0.0
009 No 0 0 0.0.0.0
010 No 0 0 0.0.0.0
Select Command= None Select Rule= N/A
Press ENTER to Confirm or ESC to Cancel:
Note: Only one LAN computer can use a trigger port (range) at a time.